Dura Life® Polyethylene Big "O" Oscillating Feeder
Features:
Polyethylene Feeder:
Polyethylene Feeder:
- Will not rust, rot or corrode - hog lot and confinement pen acids have no effect
- Slides easily - locks tight to seal out moisture.
- Patented feed distribution system and smooth, slick polyethylene inner side keeps constant, unobstructed amounts of feed flowing freely - even feeds high moisture grain without build-up or bridging.
- Feed distribution chamber is 10" above trough, so no moisture can transfer into the feed storage area.
- No need for feeder doors - water in feed pan from rain and snow is welcomed, pigs like it and so will you.
- Animal activated feed-down system keeps feed distributed evenly around trough.
- Twelve 12"-wide feed stations give plenty of space for non-competitive feeding - feeds up to 100 pigs in one pen.
- Animals stay over the trough to feed, sharply reducing waste.
- Raises or lowers feed control cone to increase or decrease the flow of feed into the feed pan.
- Stainless steel T-bar adjustment located outside on the side for easy access.
- Made of polyethylene so will never rust.
- Intermediate cone bears the weight of feed stored above, and absorbs and removes the down pressure weight from the feed control cone.
- Adjusts up or down to increase or decrease the rate of feed flow.
- After setting the rate of feed flow, there's no need to touch it again for adjustment as the feeder empties or as the size of the feeding pigs changes.
- Feed flows evenly around the cone, down into the feed drop area
- Cone forces the flow of feed to the outside for even 360° distribution into the feed pan.
- Internal cones bear the total weight of feed - all other parts move freely.
- Oscillating nose bars cause feed to drop from above, sweeping feed evenly across the feed pan.
- Built-in bumper bar causes natural vibration in the feeder to assist in free flow of feed.
- Will fit most sizes of feeders.
- An adapter ring is used to fit others.
- Do not throw away that old feeder with the rusted-out bottoms. Bolt the top half of your old feeder to a new Big "O" polyethylene base. Save big dollars.
